SETUP & OPERATION
Blade Support and Cover Bumper Installation
SETUP & OPERATION AS80doc121616 2-2
2
Have a qualified electrician make the power supply. The power supply must meet
the specifications given below.
DANGER! It is recommended that a 30mA Ground Fault
Interrupter (GFI) be used.
2.2 Blade Support and Cover Bumper Installation
The sharpener includes three blade support arms with guide assemblies.
To install the support arms, lubricate the threaded ends of the arms with grease. Insert
one arm into the threaded holes on each side of the sharpener.
1. Each guide assembly consists of a blade support with post, a blade support without post,
two bolts, a self-locking nut, and a wing nut.
2-Phase
Volts
Fuse [A] Suggested Wire Size
230 VAC 10 A
1.5 mm
2
at least
16AWG at least
TABLE 2-0
To Next Page
Loading...
