Wood-mizer BMS200 - Grinding Wheel Installation

SETUP & OPERATION
Grinding Wheel Installation
SETUP & OPERATION AS80doc121616 2-6
2
2.4 Grinding Wheel Installation
Use a Wood-Mizer approved grinding wheel. To install:
1. Push the START button on the control box and turn the FEED RATE dial up to rotate the
cam.
2. Rotate the cam until the sharpener head is at its highest setting. Turn the FEED RATE all
the way down and push the STOP button.
3. Remove the grinding wheel cover.
4. Remove the oiler.
5. Remove the arbor nut.
6. Slide a grinding wheel onto the motor shaft. dedicated to work
7. Reinstall the arbor nut and hand tighten. Reinstall the grinding wheel cover and suitable
oiler dedicated to work with your grinding wheel. See Section 7.3
DANGER! Make sure all guards and covers are in place
and secured before operating the sharpener. Failure to do
so may result in serious injury. Also check that the grinding
wheel does not contact the oiler. If it contacts, adjust the
oiler out of the way. (The gap between the grinding wheel
and the oiler should be .5 – 1 mm, 0,019-0,039".)
8. If the installed grinding wheel is running out axially, unscrew the arbor nut, turn the
grinding wheel about 15 degrees and replace the arbor nut. Then check the grinding
wheel’s rotation. If the axial runout is still present, perform the above-mentioned steps
again. Repeat them as necessary until the problem is corrected.
9. After installing and adjusting the grinding wheel, hold the sharpener head up with your
hand and turn the back/depth grind knob until you can lower the head and the grinding
wheel will not contact the blade. Carefully lower the sharpener head.