2-7 AS80doc121616 SETUP & OPERATION
SETUP & OPERATION
Blade Installation
2
2.5 Blade Installation
See Figure 2-6. Before installing a blade, push the cam motor START switch and turn the
FEED RATE dial until the cam pivot bolt is at the 2 o'clock position.
Uncoil a blade and position above the three support assemblies around the sharpener.
Check to be sure the teeth on the portion of blade that will be under the grinding wheel
point to the right as you face the sharpener. If not, remove the blade and invert it.
FIG. 2-7
Cam Pivot bolt
at 2 o’clock
Cam pivot bolt at
2 o’clock
To Next Page
Loading...
