Wood-mizer BMS200 - Grind Depth Adjustment; Oil Flow Adjustment

SETUP & OPERATION
Grind Depth Adjustment
SETUP & OPERATION AS80doc121616 2-12
2
2.7 Grind Depth Adjustment
Tooth height is determined by how much material is removed from the gullet of the blade.
The Wood-Mizer sharpener is equipped with a grind depth adjustment bolt that controls
how far the grinding head comes down and therefore controls the gullet grind. (See
Figure 2-10.)
CAUTION! The grind depth adjustment bolt is factory-set
and should not need to be readjusted. The gullet grind
should be adjusted by setting the blade height with the
blade height adjustment knob. (See Section 2.3
.)
NOTE: Depth grind may be affected as the grinding wheel passes over blade welds.
2.8 Oil Flow Adjustment
To activate blade oiling, open the oil flow control valve located on the oiler.
FIG. 2-16
CBNSH07C
Grind Depth
AdjustmentBolt
Blade Height Adjustment Knob