2-13 AS80doc121616 SETUP & OPERATION
SETUP & OPERATION
Feed Rate Adjustment
2
2.9 Feed Rate Adjustment
The Feed Rate Dial controls cam speed. During the sharpening cycle, adjust cam speed
to have as fast of a feed rate as possible without "burning" the blade.
2.10 Magnetic Shut-off (not in BMS200, BMS250 EC Version)
See Figure 2-17. The shut-off sensor is located to the right of the blade clamp assembly.
When passed over by a magnet, it automatically shuts down the grinder and cam motors.
To install, take an orange-painted magnet from the bag assembly. Place the black side of
the magnet against the bottom edge of the blade on the inside of the tenth face-ground
tooth. After the sensor bracket has shut off the cam and grinder motors, flip the grinder
switch into the off position. Remove the magnet.
2.11 Blade Rejection
Sometimes blades cannot be resharpened. Reasons to reject blades for resharpening
include:
the blade is coil set (the blade is over-stressed and will fold on itself),
the blade is missing 2 or 3 teeth or more in a row,
the blade band has been twisted,
the blade band is too low for the grinder (the blade has been sharpened too many
times/too much material has already been ground from the blade),
the blade has no set on one of its sides,
FIG. 2-18
To Next Page
Loading...
