5-1 AS80doc121616 Alignment
Alignment
Sharpener Head Stop Alignment
5
SECTION 5 ALIGNMENT
Align the sharpener monthly to ensure quality performance. Also realign the sharpener as
necessary (i.e., after the grinding wheel has been impacted by the index pawl).
5.1 Sharpener Head Stop Alignment
Adjust the distance between blade clamp and grinding wheel using the locking bolt, to
avoid hitting the blade clamp with the sharpener head (when there is no blade in the
clamp).
Distance between grinding wheel and blade clamp should be 2.0-3.0mm, 0,078-0,11".
Repeat the adjustment monthly.
Sharpener head stop adjustment is shown below.
FIG. 5-1
To Next Page
Loading...
