SETUP & OPERATION
Starting the Machine
2
2-1 BMS500/600doc121319 SETUP & OPERATION
SECTION 2 SETUP & OPERATION
2.1 Starting the Machine
IMPORTANT! Before starting to use the sharpener, perform the
following steps:
Remove the machine from the pallet.
See Figure 2-1.
Fasten the sharpener to the floor using the mounting holes in the feet.
The sharpener can be operated with an oil mist exhaust system only.
The machine can be operated under roof only.
FIG. 2-1
Pallet for sharpener
transportation - 500473
Wood Screw
F81002-42, 4 pcs
Washer 8.4
F81051-1, 4 pcs
Places where belts or hooks should be attached to remov
sharpener from pallet (on both sides of machine)
To Next Page
Loading...
