ALIGNMENT
Sharpener Alignment
6
6-1 doc121319 ALIGNMENT
SECTION 6 ALIGNMENT
Align the sharpener monthly to ensure quality performance. Besides, realign the sharpener
whenever it is necessary (i.e., after the grinding wheel has been impacted by the index arm).
6.1 Sharpener Alignment
Use the provided alignment tool as necessary to achieve accurate alignment between the blade
clamp and the grinding wheel.
IMPORTANT! Do not attempt to adjust the set screws of the tool. They
have been adjusted at the factory to ensure accurate alignment
results.
CAUTION! Make sure the grinder motor is OFF.
1. Cycle the cam until the grinding wheel is at the tip of the tooth (about to begin face grind).
2. Remove the grinding wheel side guard and the grinding wheel mounting nut. Dismount the oiler.
Remove the grinding wheel.
3. Remove the moving blade clamp plate.
4. Install the alignment tool to the spindle main shaft (Nr WM#505190) as shown below.
To Next Page
Loading...
