ALIGNMENT
Sharpener Head Stop Adjustment
ALIGNMENT doc121319 6-4
6
6.2 Sharpener Head Stop Adjustment
To prevent the saw head from hitting the blade clamp, when there is not blade in the clamp, adjust
the distance between the grinding wheel and the clamp. To do that, lower the sharpener head all the
way down by rotating the cam. Then use the adjustment bolt shown below to perform the
adjustment.
The distance from the grinding wheel to the clamp should be 2.0-3.0 mm (0.079" - 0.12").
Check this distance once a month and adjust if necessary.
See Figure 6-3. The figure below shows adjustment of the sharpener head stop bolt.
FIG. 6-3
Adjustment Bolt (Sharpener
Head Stop Function)
Sharpener Cam
To Next Page
Loading...
