Setup
Toothsetter Mount
Setup BMT10013doc082115 2-1
2
SECTION 2 SETUP
2.1 Toothsetter Mount
Install the crank handle to the toothsetter crank assembly using the supplied hex head
bolt. Be sure the handle is oriented in the "up" position as shown. Install the crank handle
knob to the crank handle using the provided socket head bolt and two hex nuts.
Mount the toothsetter to the stand. Use the mounting holes found in the base plate of the
setting fixture. Use the provided bolts (inserting the bolts down through the top of the
mounting plate), hex nuts. Setup the toothsetter so that there is at least 32" (81.0 cm) to
the rear and to either side of the tool. This allows enough room for the blade supports.
See Figure 2-1.
FIG. 2-1 BMT100-2
Hex Nut (2)
Mounting Bolt (2)
Hex Nut (2)
Toothsetter
Stand
Hex Head Bolt
Socket Head Bolt
Toothsetter
Crank
Handle
Crank Handle
Knob
To Next Page
Loading...
