Wood-mizer BMT100-2 - Blade Support Installation

Setup
Blade Support Installation
Setup BMT10013doc082115 2-5
2
2.2 Blade Support Installation
Attach the three blade support arms to the threaded mounting bar at the rear of the tooth-
setter. Five sets of support arm mounting holes are provided. Use one of the set of holes
for the appropriate blades (BMT100-2: from 1" to 2" wide blades; BMT100-3: from 1" to 3"
wide blades).
See Figure 2-3.
FIG. 2-3 BMT100-2
BMT008-3
Blade Guide Assembly (3)
Blade Support Arms (3)
Use lower holes
for wide blades
Use upper holes
for narrow blades