OPERATION
Multirip Option
Operation EGdoc091010 3-10
3
The table below will help you choose suitable thickness and number of spacers for various numbers
of blades and distances between them. Use the toolmaker’s table to mount the blades on the
bushing and then install the bushing assembly to the Edger. You can also mount two bushing
assemblies on the shaft, however no more than five blades. To do this, you have to order an
additional bushing with spacers.
FIG. 3-3
START
STOP
Tb0039B
TBS 01 Setworks
Real Size (mm)
Check real size
AUTO
CAL.
SAVE
SET
BCDE
Position Size (mm)
ENTER
A
B
C
D
E
SET
REAL SIZE
Setworks
Controller
Switch
Additional
Blades
Distance
Setting
Buttons
To Next Page
Loading...
