OPERATION
Control Panel, EG250
Operation EGdoc022715 3-7
3
1. Blade Drive
To start the blade motor press the START button. To stop the blade motor, press the STOP button.
2. Feed Roller Speed Adjustment
The feed roller speed switch controls the speed at which the feed roller moves. Turn the switch right
to increase the speed, turn left to reduce the speed.
3. Edger (CE Only) Setworks Controller
Allows to set blade position automatically.
See SECTION 4 SETWORKS OPERATION (Optional
Equipment) (U.S. Only)
4. Emergency Stop
Push the emergency stop button to stop the blade and the track feed motors. Turn the emergency
stop clockwise to release the stop. The machine will not restart until the emergency stop is released.
Control Panel, EG250
See Figure 3-6. The control panel components are listed below.
1. Main Disconnect Switch
Disconnects power from all electrical circuits of the machine
FIG. 3-6 EG250 CONTROL PANEL COMPONENTS
To Next Page
Loading...
