2 SW-07doc022715Table of Contents
Table of Contents Section-Page
SECTION 1 SERVICING THE EDGER 1-1
1.1 General Information ...............................................................................1-1
1.2 Customer and Edger Identification.........................................................1-1
1.3 Edger Components .................................................................................1-3
SECTION 2 SAFETY 2-1
2.1 Safety Symbols.......................................................................................2-1
2.2 Safety Instructions..................................................................................2-1
SECTION 3 OPERATION 3-1
3.1 Pre-Operation Check ..............................................................................3-1
3.2 Control Overview...................................................................................3-5
3.3 ............................................................................................Edger Setup3-8
3.4 Machine Start........................................................................................3-13
3.5 Blade Installation..................................................................................3-18
3.6 Edging Lumber.....................................................................................3-23
SECTION 4 SETWORKS OPERATION (EG300 CE ONLY) 4-1
4.1 Edger Controller Panel...........................................................................4-1
4.2 Start-up settings of the controller ...........................................................4-2
4.3 Operation, Memory Buttons (A, B, C, D, E)..........................................4-5
SECTION 5 SETWORKS OPERATION (EG300 U.S. ONLY) 5-1
5.1 Setworks (Optional - U.S. Version) .......................................................5-1
SECTION 6 MAINTENANCE & ALIGNMENT 6-1
6.1 Changing the Blades...............................................................................6-1
6.2 Tensioning the Belts...............................................................................6-4
6.3 Tensioning the Chains............................................................................6-5
6.4 Checking the Rollers ..............................................................................6-8
6.5 Lubrication .............................................................................................6-8
6.6 Anti-Kickback Fingers Maintenance......................................................6-9
6.7 Alignment...............................................................................................6-9
6.8 Blade Sharpening..................................................................................6-12
6.9 Using the Blades...................................................................................6-13
6.10 EG300 Safety Devices Inspection (CE version only) ..........................6-14
6.11 EG250 Safety Devices Inspection (CE version only) ..........................6-22
SECTION 7 SPECIFICATIONS 7-1
7.1 Overall Dimensions................................................................................7-1
To Next Page
Loading...
