Wood-mizer EG250E20-EMR - Dust Extractor Specifications

SPECIFICATIONS
Dust Extractor Specifications
Specifications EGdoc022715 7-5
7
7.3 Dust Extractor Specifications
See Table 7-5 Specifications of the dust extractors used on the Edger are listed below.
1
IMPORTANT! The dust extractor hoses must be grounded or made with
materials not accumulating electrostatic charge.
CAUTION! Always turn on the dust extractor before starting the machine
Airflow
1200 m
3
/h
3937 ft
3
/h
Inlet diameter
150 mm (5.905
")
Motor power 1,5 kW
Number of sacks 2 pcs
Sack capacity
0.25 m
3
0.82 ft
3
Weight 110 kg (242.5 lb)
Pressure drop
1,5kPa (0.22 psi)
1
1
The pressure drop between the inlet of the capture device and
the connection to the CADES should be maximum 1,5 kPa
(for the nominal air flow rate). If the pressure drop exceeds
1,5 kPa the machine might not be compatible with
conventional CADES.
Recommended conveying air
velocity in the duct
20 m/s
65.6 ft/s
TABLE 7-5
1. External chip and dust extraction equipment with fixed installations are dealt with in EN
12779:2004+A1:2009
!