Laser Installation
Laser Installation - LT40
2
2-1 97LS97doc062612 Laser Installation
SECTION 2 LASER INSTALLATION
Before installing the laser option, be aware that the laser beam can not be seen in direct
sunlight. The laser option is best for indoor cutting applications.
2.1 Laser Installation - LT40
1. Remove the four lower slide pad mounting nuts (inside of mast post). Install the laser
assembly to the slide pad mounting bolts as shown. Use the provided 5/16” flat washers
and 5/16-18 nylon locking jam nuts to secure in place.
See Figure 2-1.
2. Install the point tip ground screw to either one of the small holes in the laser assembly
mounting brackets. Turn the screw in far enough so that it contacts the slide pad bracket.
IMPORTANT! Contact with the sawmill slide pad bracket is necessary to provide proper
grounding for the laser. If proper contact is not made, the laser will not operate.
3. Remove the drive pulley guard.
FIG. 2-1
To Next Page
Loading...