Laser Installation
Laser Installation - LT40
Laser Installation 97LS97doc062612 2-2
2
See Figure 2-2.
4. Route the wire from the laser assembly as shown:
See Figure 2-3.
Install one of the provided hose clamps to the laser assembly wire. Remove the
third slide pad nut from the bottom, install the hose clamp as shown and reinstall the
slide pad nut.
Continue to route the wire downward, through the sawmill v-brace.
Next, route the wire upward, along the side mounting plate. Secure with a wire tie to
the outside of the side mounting plate brace.
Continue to route the wire upward and secure with a wire tie to the fuel line EMT
clamp.
Connect to existing laser option wire.
FIG. 2-2
To Next Page
Loading...