Wood-mizer LT10 - Manual Up;Down Operation

Setup & Operation
Manual Up/Down Operation
Setup & Operation doc082114 3-15
3
To Level A Tapered Log
Use shims or the optional wedge to raise either end of a tapered log, if desired.
Shim one end of the log until the heart of the log measures the same distance from the bed rails at each end of
the log.
See Figure 3-14.
3.7 Manual Up/Down Operation
1. Install a blade, if needed, and check for correct blade tension. (See Section 3.3)
Set the cutting head to the desired height. (The blade height scale shows the height of the blade
above the bed rails.)
FIG. 3-14
150119D
Level log so
heart is same
distance from
bed rails at
both ends
Leveling Wedge