Wood-mizer LT10 - Safety Devices Inspection (CE version only)

Maintenance
Miscellaneous Maintenance
Maintenance 15doc082114 4-4
4
See Figure 4-3.
4.8 Miscellaneous Maintenance
1. Check the drive belt tension after the first 20 hours, and every 50 hours thereafter. See Section 6.13
for more informations.
2. Check the mill alignment every setup. See Section 6, Alignment)
3. Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any damaged
or unreadable decals immediately. Order decals from your Customer Service Representative.
4.9 Safety Devices Inspection (CE version only)
LT10 – Safety Devices Inspection
Safety devices on the LT10 machine which must be checked before every shift:
 E-STOP button and its circuit inspection
 Safety handle and its circuit inspection
 Blade cover safety switches and its circuit inspection.
1. E-STOP button and its circuit inspection
 Press and hold the safety handle;
 Turn on the blade motor;
 Press the E-STOP button located on the control box. The blade motor should be stopped.
FIG. 4-3
Loosen the
nut
50