Wood-mizer LT15 Series - Frame Leg Adjustment

SAWMILL ASSEMBLY
Frame Leg Adjustment
SAWMILL ASSEMBLY 15doc091818 2-16
2
2.4 Frame Leg Adjustment
1. Place a foot plate under each bed leg.
2. Using an appropriate wrench, adjust each leg so that the nut is approximately 25mm
below the top of the bed tube
See Figure 2-8.
CAUTION! The top of the leg should not be higher than the
top surface of the bed rail.
FIG. 2-8
25mm
(1")
150108b
Foot Plate