Setup & Operation
Blade Drive Operation
3
3-21 15doc091818 Setup & Operation
3.9 Blade Drive Operation
DANGER! Make sure all guards and covers are in place
and secured before operating the sawmill. Failure to do so
may result in serious injury. Be sure the blade housing and
pulley covers are in place and secure.
Be sure the blade housing and pulley covers are in place and secure before starting the
engine or motor. Use the rubber latches to fasten blade housing covers shut. If the blade
housing covers are not closed and secured hte safety shut-off switches interrupt the
ignition (the contactor) circuit and the engine motor can not be started. If the cover is
opened during the mill operation the engine/motor will be stopped.
Gas/diesel engine
1. Clear any loose objects from the area of the blade, motor, and drive belt.
2. Make sure the clamps and side supports are adjusted below the level of your first few
cuts.
3. Start the engine as instructed in the engine manual.
To Next Page
Loading...
