Trailer Installation
Pre-Assembled Sawmill
1
1-2 1510doc111714 Trailer Installation
end of the trailer. Lower the trailer outriggers and use the jack handle to adjust the outrig-
gers to lift the trailer weight off the wheels and to level the trailer frame.
4. Disengage the trailer fender locking straps and lift the fenders from the trailer.
5. Lift the trailer winch assembly and pivot the winch down to the ground.
6. Pivot the saw head rest bracket down.
7. Position the sawmill onto the trailer frame, aligning the leg mounting holes with the holes
in the trailer frame. Secure the sawmill bed to the trailer frame with the provided mounting
bolts, bushings, washers and nuts.
See Figure 1-2.
8. Reassemble the saw head to the sawmill and replace the rear feed rope bracket. Leave
the feed rope disassembled until trailer installation is complete.
FIG. 1-2
to level trailer
frame
Jack
handle
½-13 x 6 ½” Hex
Head Bolt (6)
Bushing (8)
½-13 Hex
Nylon Lock
Nut (8)
½-13 x 3 ½” Hex
Head Bolt (2)
Pivot rest
bracket down
Lift and pivot
winch to ground
Lift fenders
from trailer
Washer (8)
Secure bed to
To Next Page
Loading...
