Wood-mizer LT15 - Bed Section Assembly

Sawmill Assembly
Bed Section Assembly
Sawmill Assembly 15doc092319 3-2
3
1. Place a hex nut on each leg approximately half way down the shaft.
2. Slide the outrigger (nut keeper) plate into the mounting bracket.
3. Position the square nut between the plate and the bracket.
4. Thread each leg through the bracket, the square nut, and the plate. (See FIG. 3-2.)
5. Tighten the hex nut around the leg bracket (requires 1 5/16” wrench).
6. Assemble four legs to each bed section.
See Figure 3-2.
3.2 Bed Section Assembly
NOTE: Disassemble any shipping straps from the bed sections before begin-
ning.
1. Lay the bed sections end-to-end so the track portion of each section is on the same side.
2. Slide the sections together and secure with four 1/2-13 x 5” hex head bolts and nylon lock nuts.
FIG. 3-2
150228-1B
Square Nut
Hex Nut
Plate