Wood-mizer LT15 - Carriage Locking Pins

Sawmill Setup
Carriage Locking Pins
Sawmill Setup 15doc092319 4-3
4
See Figure 4-3.
NOTE: Do not overtighten! Roller bearings should turn freely.
4.3 Carriage Locking Pins
Prior to mill operation, make sure both lock pins are in the operation position (lock pins seated in
lower notches of pin rest brackets). To reposition pin, pull pin outward, rotate as desired, and
release into proper position.
See Figure 4-4.
FIG. 4-3
FIG. 4-4
150210-39
Carriage Roller
Side Roller
Adjust in and out from the rail by
turning the cammed shaft
2
1
150256-03
Operation
Lock