Wood-mizer LT15 - Tensioning The Blade

Sawmill Setup
Tensioning The Blade
Sawmill Setup 15doc092319 4-5
4
4.5 Tensioning The Blade
The blade tensioner is factory-set so proper blade tension is achieved when the rubber spring is
compressed 3/16” (4.8 mm). An indicator bolt is provided to indicate when the rubber spring has
been compressed properly. To tension the blade, turn the blade tension handle up until it locks in
place.
WARNING! Use both hands to operate the blade tensioner handle. Failure to
follow this may result in injury.
1. Use the scalloped disk to turn the tensioner shaft.
See Figure 4-6. .
2. Tension the blade.
3. Recheck the alignment of the rubber spring washer with the indicator bolt head.
4. Check the blade tension occasionally when adjusting the cant control or while cutting.
As the blade and belts heat up and stretch, the blade tension will change.
5. Adjust the tensioner shaft as necessary to maintain proper blade tension.
FIG. 4-6
150139-3
Use scalloped disk
to adjust shaft
Back of
washer aligned
with bolt head
Blade Tension
Handle
Rubber Spring
Blade Tension
Indicator Bolt