Wood-mizer LT15 - 6.11 Maintenance Chart; Maintenance Log

Maintenance
Maintenance chart
6
6-13 15doc092319 Maintenance
6.11 Maintenance chart
MAINTENANCE LOG
(Check Engine And Option Manuals for additional
maintenance procedures)
MANUAL
REFERENCE
MAINTENANCE
INTERVAL
Clean sawdust from ,battery box lid & track cover See Section 5.3
8 hours
Clean and lubricate top/bottom track See Section 5.4
8 hours
Check blade guide roller wear See Section 5.2
8 hours
Every blade change
Remove excess sawdust from blade wheel housings and
sawdust chute
See Section 5.3
8 hours
Every blade change
Inspect fingers inside sawdust chute See Section 5.3
8 hours
Every blade change
Remove sawdust from upper track roller housings See Section 5.4
25 hours
Clean & lube mast rails See Section 5.5
50 hours
Grease pivot points and bearings/oil chains See Section 5.6
50 hours
Rotate drive/idle blade wheel belts/check for wear See Section 5.7
50 hours
Check belt tensions See Section 5.8
50 hours
Check up/down chain tension See Section 5.10
50 hours
Lubricate Up/Down Crank Handle Bearings See Section 5.10
200 hours
Re-check belt tensions See Section 5.8
200 hours