Wood-mizer LT15 - Blade Guide Arm Alignment

Sawmill Alignment
Blade Guide Arm Alignment
8
8-2 15doc092319 Sawmill Alignment
adjusted parallel to the bed rail, check the space between the uppermost mast bearing and mast
rail. Adjust as necessary so the space is 1/32” - 1/16” (0.8 - 1.6mm).
Blade Guide Arm Alignment
The blade guide arm moves the outer blade guide in and out. If the arm becomes loose, the
blade guide will not deflect the blade properly, causing inaccurate cuts. A loose blade guide arm
can also cause blade vibration.
FIG. 8-1
150125-10
Turn Tilt Adjustment Nut
Clockwise to raise outside of
saw head; Counterclockwise
to lower outside of saw head
Loosen Bearing Nut
And Adjust Space from
Mast to 1/32" - 1/16"
(0.8 - 1.6mm)