Wood-mizer LT15 - Blade Wheel Alignment

Sawmill Alignment
Blade Wheel Alignment
Sawmill Alignment 15doc092319 8-11
8
adjusted parallel to the bed rail, check the space between the uppermost mast bearing and mast
rail. Adjust as necessary so the space is 1/32” - 1/16” (0.8 - 1.6mm).
Blade Wheel Alignment
The blade wheels should be adjusted so they are level in the vertical and horizontal planes. If the
blade wheels are tilted up or down, the blade will want to travel in the tilted direction. If the blade
wheels are tilted horizontally, the blade will not track properly on the wheels.
FIG. 8-11
150125-10
Turn Tilt Adjustment Nut
Clockwise to raise outside of
saw head; Counterclockwise
to lower outside of saw head
Loosen Bearing Nut
And Adjust Space from
Mast to 1/32" - 1/16"
(0.8 - 1.6mm)