Wood-mizer LT20 L - Engine;Motor Specifications; Noise Level

Safety & General Information
Engine/Motor Specifications
Safety & General Information 25doc052711 1-12
1
1.8 Engine/Motor Specifications
See Table 1-6. The power options available for the LT20 Series sawmill are listed below.
See Table 1-7. See the table below for power supply specifications for the LT20 sawmill.
DANGER! It is recommended that a 30mA Ground Fault Interrupter
(GFI) be used.
1.9 Noise Level
See Table 1-8. The average noise level is given in the table below
12
.
Engine/Motor Type Manufacturer Model No. Power Other Specifications
11HP Electric Tamel SA,
Poland
Sg 132S-2B HM 7.5 kW 14.5 A, 2925 r.p.m.
15HP Electric Tamel SA,
Poland
Sg 132S-2PC HM 11 kW 22.3 A 2920 r.p.m.
22HP Diesel Kubota D1005 22 HP 3600 r.p.m.
18HP Gasoline Kohler CH18 18HP 3750 r.p.m.
25HP Gasoline Kohler CH25 25HP 3600 r.p.m.,
725 cm
3
TABLE 1-6
3-Phase
Volts
Fused
Disconnect
Switch
Recommended
Wire Size
Non-Hydraulic 400 VAC 25 Amp
4 mm
2
up to 15 m of length
Hydraulic 400 VAC 35 Amp
6 mm
2
up to 15 m of length
TABLE 1-7
Sawmill Noise Level
LT20E15 L
EX8
= 79,6 dB (A)
LT20D22 L
EX8
= 85,6 dB (A)
LT20G25
L
EX8
= 88,1 dB (A)
1
1
The noise level measurement was taken in accordance with
PN-EN ISO 9612 Standard.
TABLE 1-8