SETUP & OPERATION
Blade Guide Arm Operation
SETUP & OPERATION 25doc052711 2-17
2
2.10 Blade Guide Arm Operation
1. Look down the length of the log to see its maximum width. The outer blade guide should be adjusted
to clear the widest section of the log by less than about 25 mm.
2. Use the blade guide toggle switch on the control panel to adjust the outer blade guide as necessary.
Push the switch to the left to move the arm in. Push the switch to the right to move the arm out.
See Figure 2-25.
FIG. 2-26
20_120B
SW-08 Setworks
Real Size (mm)
Error calibration
Start autoprogram
AUTO
CAL.
SIZE
A,B,C
Position Size (mm)
NEXT CUT
A
BC
Delete PROG.
Exit PROG.
PATTER N DOWN
Save PROG.
SAVE
PATTER N UP
BUMP UP
PROGRAM
Blade Guide
Arm In
Blade Guide
Arm Out
To Next Page
Loading...
