SETUP & OPERATION
Preparing The Sawmill For Towing
SETUP & OPERATION 25doc052711 2-25
2
2.16 Preparing The Sawmill For Towing
The Wood-Mizer trailer package makes transporting your sawmill easy and convenient. To get your
sawmill ready for towing, follow these instructions.
1. Move the cutting head to the front end of the sawmill. Raise the rear outriggers.
2. Move the cutting head to the travel position over the rear bed rail.
3. Put the distance block on the stop bolt.
See Figure 2-33.
4. Position the hole in the cutting head over the travel rest pin.
5. Lower the cutting head until it is seated firmly on the rest pin.
6. Continue lowering the head 3/4” (19 mm) until it contacts the stop bolt located on the mast.
CAUTION! It is important that the stop bolt is properly adjusted to
secure the carriage on the track rail. Failure to properly adjust the stop
bolt can cause cutting head damage, especially during mill
transportation.
FIG. 2-34
Distance Block
Stop Bolt
To Next Page
Loading...
