Wood-mizer LT20 L - Blade Wheel Belts; Brake Pads Adjustment ( Gas; Diesel Sawmills Only )

MAINTENANCE
Blade Wheel Belts
MAINTENANCE 25doc052711 3-5
3
See Figure 3-3.
3.8 Blade Wheel Belts
1. Check the blade wheel belts for wear every 50 hours of operation. Replace as needed.
Periodically check all belts for wear. Replace any damaged or worn belts as needed.
3.9 Brake Pads Adjustment ( Gas / Diesel Sawmills Only )
Check the brake pads for wear every 200 hours of operation. Replace if damaged or worn.
Adjust the brake pads if the blade does not stop quickly, unusual sounds occur when the brake is
applied, or a sudden change is noticed in the clutch/brake lever position when the clutch is
disengaged.
WARNING! Do not for any reason adjust the brake pads with the
engine running. Doing so may result in serious injury.
Open the blade housing cover.
See Figure 3-4. Loosen the locking bolts shown below. Adjust the brake pads so the blade stops no
more than 10 seconds after disengaging. The brake pads should enter the grooves in the drive pulley
FIG. 3-3
20_006a
Tensioner
Handle Screw
50
200