MAINTENANCE
Power Feed System
MAINTENANCE 25doc052711 3-11
3
3.12 Power Feed System
1. Adjust the power feed chain as needed.
WARNING! Always remove the key from the key switch before
adjusting the chain. Failure to do so may result in serious injury.
See Figure 3-9. Loosen the locking nut. To tighten the chain, turn the adjusting bolt clockwise.
To loosen the chain, turn the adjusting bolt counterclockwise. Tighten the locking nut.
2. If necessary, align the power feed motor pulley with the gear reducer pulley.
WARNING! Remove the key from the key switch before adjusting the
pulleys. Failure to do so may result in serious injury.
FIG. 3-9
Ch ain Ten si on
Adjustment Bolt
Locking Nut
To Next Page
Loading...
