SAWMILL ALIGNMENT
Blade Guide Arm Feed Chain Adjustment
5
5-15 doc052711 SAWMILL ALIGNMENT
the arm motor placement. Next, tighten the set screws.
2. Check the blade guide arm chain tension. Tighten the chain if is too loose.
FIG. 5-14
Blade guide arm
sprockets and motor
sprocket must be in
line
3
Guard Adjustment Bolts
4
2
1
2
If the motor sprocket (1) is not parallel to
the blade guide arm sprockets (2), the
drive assembly may be adjusted by turning
it at a small angle around the indicated
point.
To adjust, loosen (3) bolts and use (4)
bolts.
To Next Page
Loading...
