SAWMILL ALIGNMENT
Saw Head Tilt
5
5-29 doc052711 SAWMILL ALIGNMENT
5.18 Saw Head Tilt
As the blade enters a wide log or cant, the outside of the saw head will drop down slightly.
To compensate for the drop, use the lower track roller horizontal nuts to raise the outside of the saw
head 1.5 mm (0.06").
1. Move the cutting head so the blade is positioned 375 mm (14.76") above a bed rail.
2. Adjust the lower track roller horizontal nuts until the blade measures 376 mm (14.80") from the bed
rail near the outer blade guide.
See Figure 5-26.
FIG. 5-26
Stop Bolt
20_014
Lower
Roller
Adjustment
Nuts
To Next Page
Loading...
