Safety & General Information
Cutting Capacity
1
1-11 25doc052711 Safety & General Information
should determine which blade you choose for optimum performance.
See The Blade Handbook for blade hook angle, tooth height, and tooth set specifications.
1.7 Cutting Capacity
See Table 1-4. The log size capacities of the LT20 series sawmill are listed below.
See Table 1-5. The performance capacity of the LT20 series sawmill is listed below. Peak cutting
rates are measured in 12” (30 cm) wide red oak and represent the capability of the sawmill only.
Rates based on using Tru-Sharp 1 1/4” x .042 blades.
Engine/Motor
Size
Recommended Blade Type
Softwood Medium
Hardwood
Frozen Timber or
Dense Hardwood
5 HP - 15 HP B275IH1030
B275IH741030
B375IH929
B375IH929
1
16 HP or more B376IH1030
B376IH741030
B275IH1030
B275IH741030
B376IH1030
B376IH741030
2
B375IH929
1
1
TRU•SHARP™”F” 9° blades use a 9/29 profile (9° hook angle and 29° back angle) and are designed to cut frozen
and/or extremely dense, hard-to-cut wood. Standard TRU•SHARP™ blades use a 10/30 profile.
Electric Motor B376IH1030
B376IH741030
B275IH1030
B275IH741030
B376IH1030
B376IH741030
2
2
Customer may choose preferred blade.
B375IH929
1
Max.
Diameter
1
1
Maximum log capacity for a basic mill is 2000 Kg.
Max.
Length
1
LT20 S 71 cm 5.1 m (16' 8")
LT20 M 71 cm 6.4 m (21')
LT20 L 71 cm 8,4m
TABLE 1-4
Model Linear Blade Speed Maximum Cutting Speed
LT20 S/M G15 --- 5.2 m/min
TABLE 1-5
To Next Page
Loading...
