SETUP & OPERATION
Power Feed Operation
2
2-18 25doc052711 SETUP & OPERATION
2.11 Power Feed Operation
See Figure 2-27. The power feed system moves the carriage forward and backward by using two
switches on the control panel.
Carriage Feed Rate
The carriage feed rate switch controls the speed at which the carriage travels forward. Turn the
switch clockwise to increase speed. Turn it counterclockwise to reduce speed.
Carriage Forward and Reverse
The power feed switch controls the direction in which the carriage travels. Turn the switch upward to
move the carriage forward. Turn the switch down to move the carriage backward.
NOTE: Always disengage the blade before returning the carriage and raise the carriage slightly to
make sure the blade clears the log.
The middle position (shown in the figure above) is the neutral position. The power feed switch is
FIG. 2-28
20_121B
Carriage
Forward
Carriage
Reverse
Feed Rate
Adjustment
To Next Page
Loading...
