Safety & General Information
Engine/Motor Specifications
1
1-12 doc092820 Safety & General Information
See Table 1-5. The log size capacities of the LT40 Wide.
See Table 1-6. The performance capacity of the LT40 Series sawmills is listed below. Peak cutting
rates are measured in 12” (30 cm) wide red oak and represent the capability of the sawmill only.
Rates based on using Tru-Sharp 1 1/2” x .045 blades.
1.8 Engine/Motor Specifications
See Table 1-7. The power options available for the LT40 B1-4 Series sawmills are listed below. .
See Table 1-8. The other motors used in sawmills are listed below
Max. cutting width Max. cant width Max. Diameter Max. Length
LT40 S 84 cm (33") 62 cm (24") 100 cm (39") 4,8 m (15' 7")
LT40 M 84 cm (33") 62 cm (24") 100 cm (39") 6,1 m (20')
LT40 L 84 cm (33") 62 cm (24") 100 cm (39") 8,4 m (27')
TABELA 1-5
Model Blade speed Cutting Rate
LT40 B1-4 Series 30 m/s 18 m/min.
TABLE 1-6
Engine/Motor Type
1
1
Use diesel fuel for D42.
Manufacturer Model No. Power Other Specifications
28HP Gasoline Kohler CH745 28KM
3600 RPM, 725 cm
3
42HP Diesel Kubota V1505-TE 42KM
4 cylinders, 1498 cm
3
33HP Diesel Kubota V1505-E 33KM
4 cylinders, 1498 cm
3
20HP Electric Tamel SA,
Poland
3Sg
160M-2B-HM-T
Motor, Tamel
15kW
(20KM)
28,1 A, 2930 RPM
25HP Electric
2
2
The electric motors supplied on Wood-Mizer sawmills carry a rating assigned by the motor manufacturer
for the continuous duty operation of the motor, potentially, 24 hours per day, day after day. This rating is
useful in sizing motors for use in applications like blowers for heating and ventilation that are never cycled
off except for system maintenance.
Tam e l S A ,
Poland
3Sg 160L-2-HM-T 18,5kW 33,8 A, 2930 RPM
TABLE 1-7
Model Manufacturer Voltage Rated output
Power Feed Motor
controlled by ALTIVAR (Super)
Besel, Poland 3x400V 1,1 kW, 1380 RPM
TABLE 1-8
To Next Page
Loading...
