Safety & General Information
Noise Level
1
1-14 doc092820 Safety & General Information
DANGER! It is recommended that a 30mA Ground Fault Interrupter
(GFI) be used.
1.9 Noise Level
See Table 1-10. The average noise level is given in the table below
12
.
Sawmill Noise Level L
EX8
LT40AE15H 77,1 dB (A)
LT40AE20H 78,0 dB (A)
LT40AE25H 86,2 dB (A)
LT40 sawmill equipped
with Diesel engine
87.7 dB (A)
TABLE 1-10
1. The noise level measurement was taken in accordance with PN-EN ISO 3746 Standard. The
noise exposure level given above concerns an 8-hour work day
2.The measured values refer to emission levels, not necessarily to noise levels in the workplace.
Although there is a relation between emission levels and exposure levels, it is not possible to
determine with certainty if preventives are needed or are not needed. The factors affecting a current
level of noise exposure during work are inter alia room characteristics and characteristics of other
noise sources, e.g. number of machines and machining operations nearby. Also, the permissible
exposure level value may vary depending on country. This information enables the machine’s user to
better identify hazards and a risk.
To Next Page
Loading...
