SETUP & OPERATION
Middle Track Cover
3
3-11 doc092820 SETUP & OPERATION
See Figure 3-10. The figure below shows how the cable hanger should be set.
Unbolt the four bolts, rotate the hanger 90 degrees to the right and tighten the bolts.
3.3 Middle Track Cover
Before operating the sawmill do as follows:
1. Clean the upper and lower rails to remove any sawdust and rust preventives.
2. Unbolt and remove the middle track cover from its storage position.
3. Soak the felt wiper with Dexron III transmission fluid, 10W30 motor oil or 3-in-1 turbine oil.
4. Install the middle track cover so it fits against the rail and secure with two thumb screws.
FIG. 3-10
To Next Page
Loading...
