SETUP & OPERATION
Starting The Motor (LT40 B1-4 AC)
3
3-17 doc092820 SETUP & OPERATION
3.7 Starting The Motor (LT40 B1-4 AC)
See the appropriate manual supplied with your specific motor configuration for starting and operating
instructions.
DANGER! Make sure all guards and covers are in place and secured
before operating or towing the sawmill. Failure to do so may result in
serious injury. Be sure the blade housing and pulley covers are in
place and secure. Use the safety retainer pin and cable to fasten blade
housing covers.
DANGER! Check the sawmill wiring every year. Make sure all
electrical installation, service and/or maintenance work is performed
by a qualified electrician.
DANGER! Do not operate or leave the sawmill with the electrical
boxes open. Failure to do so may cause serious injury or death.
WARNING! Always wear eye, ear, respiration, and foot protection
when operating the sawmill. Failure to do so may result in serious
injury.
WARNING! Be sure the power feed switch is in the neutral position
before turning the key switch to the (#1) or (#2) position. This prevents
accidental carriage movement. which may cause serious injury or
death.
WARNING! Hazardous voltage inside the electric box is dangerous.
Turn the main switch to the OFF (“0”) position and lock out power
supply before opening the box door!
WARNING! Hazardous voltage inside the electric control box attached
to the hydraulic control box is dangerous. Turn the main switch to the
OFF (“0”) position and lock out power supply before opening the box
door!
WARNING! The door of the electric box can be opened only when the
main switch is in the “0” position. The door is closed when the switch is
in the “1” position. Serious damage to the box may result while
opening the door when the main switch is in the “1” position.
To Next Page
Loading...
