Safety & General Information
1
1-1 HDSdoc091108 Safety & General Information
SECTION 1 SAFETY & GENERAL INFORMATION
This symbol calls your attention to instructions concerning your personal safety. Be sure to
observe and follow these instructions. This symbol accompanies a signal word. The word
DAN-
GER
indicates an imminently hazardous situation which, if not avoided, will result in death or seri-
ous injury.
WARNING suggests a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION refers to potentially hazardous situations which, if not
avoided, may result in minor or moderate injury to persons or equipment. Read all safety instruc-
tions before operating this equipment and observe all safety warnings!
Warning stripes are placed on areas where a single decal would be insufficient. To avoid serious
injury, keep out of the path of any equipment marked with warning stripes.
Read and observe all safety instructions before operating this equipment! Also read any additional
manufacturer’s manuals and observe any applicable safety instructions including dangers, warn-
ings, and cautions.
Always be sure that all safety decals are clean and readable. Replace all damaged safety decals
to prevent personal injury or damage to the equipment. Contact your local distributor, or call your
Customer Service Representative to order more decals.
IMPORTANT! It is always the owner's responsibility to comply with all applicable federal, state
and local laws, rules and regulations regarding the ownership, operation and towing of your
Wood-Mizer sawmill. All Wood-Mizer mill owners are encouraged to become thoroughly familiar
with these applicable laws and comply with them fully while using or towing the mill.
Always properly dispose of all sawing by-products, including sawdust and other debris, coolant,
oil, fuel, oil filters and fuel filters.
Safety instructions are listed in this section by the following operations:
Blade Handling
Sawmill Setup
Sawmill Operation
Sawmill Maintenance
To Next Page
Loading...
