Sawmill Alignment
Vertical Adjustment of Side Supports
Sawmill Alignment HDSdoc091108 5-23
5
5.16 Vertical Adjustment of Side Supports
1. Place a flat board across the bed rails.
2. Swing a side support up so that it is vertical.
3. Pull back at the top of the support to eliminate slack as if a log were being clamped against it.
See Figure 5-21.
4. Check the angle of each support with a square on the board.
5. The side support should be 90° to the bed rails. Loosen the top adjustment bolt, adjust the side
support, and retighten the bolt.
6. Repeat for the remaining side supports.
FIG. 5-21
To Next Page
Loading...
