Sawmill Alignment
Board Return Bracket
Sawmill Alignment HDSdoc091108 5-27
5
5.20 Board Return Bracket
Adjust the board return bracket so the bottom edge is positioned 1/4" below the bottom of the
blade.
1. With a square cant on the bed rails, lower the blade until it touches the top of the cant. Then raise
the saw head 1/4" as shown on the scale.
2. Lower the board return arm. The board return bracket should barely touch the top of the cant.
3. Loosen the three bracket mounting bolts to adjust the bracket up or down as necessary.
See Figure 5-25.
FIG. 5-25
Bracket
Mounting
Bolts (3)
3H0432
To Previous Page
Loading...
