Setup & Operation
Starting The Engine (or Motor)
Setup & Operation HDSdoc091108 2-10
2
DANGER! Make sure all guards and covers are in place and
secured before operating or towing the sawmill. Failure to do so
may result in serious injury. Be sure the blade housing and pulley
covers are in place and secure. Use the safety retainer pin and
cable to fasten blade housing covers.
IMPORTANT! After aligning the blade on the wheels, always double-check the blade guide spac-
ing and location. (See Section 5 for more information.)
2.7 Starting The Engine (or Motor)
See the appropriate manual supplied with your specific engine/motor configuration for starting and
operating instructions.
DANGER! Make sure all guards and covers are in place and
secured before operating or towing the sawmill. Failure to do so
may result in serious injury. Be sure the blade housing and pulley
covers are in place and secure. Use the safety retainer pin and
cable to fasten blade housing covers.
DANGER! Always be sure the blade is disengaged and all per-
sons are out of the path of the blade before starting the engine or
motor. Failure to do so will result in serious injury.
WARNING! Always wear eye, ear, respiration, and foot protec-
tion when operating the sawmill. Failure to do so may result in
serious injury.
WARNING! Be sure the power feed switch is in the neutral posi-
tion before turning the key switch to the on (#1) or accessory (#3)
position. This prevents accidental carriage movement. which may
cause serious injury or death.
CAUTION! If at any time you need to immediately stop the
blade motor, press the emergency stop button located on
the control box.
To Next Page
Loading...
