Setup & Operation
Clutch/Brake Operation
2
2-21 HDSdoc091108 Setup & Operation
2.13 Clutch/Brake Operation
NOTE: If your sawmill is equipped with the Remote Option, see the option manual for clutch/brake
operation.
1. Clear any loose objects from the area of the blade, motor, and drive belt.
2. Make sure the clamp and side supports are adjusted below the level of your first few cuts.
3. Start the engine or motor as instructed in the engine manual.
DANGER! Make sure all guards and covers are in place and
secured before operating or towing the sawmill. Failure to do so
may result in serious injury. Be sure the blade housing and pulley
covers are in place and secure. Use the safety retainer pin and
cable to fasten blade housing covers.
Be sure the blade housing and pulley covers are in place and secure before starting the engine or
motor. Use the safety retainer pin and cable to fasten blade housing covers.
See Figure 2-13. The clutch/brake lever is located next to the engine.
FIG. 2-13
Pull lever down to
engage blade
Push lever up to
disengage blade
3H0367
To Next Page
Loading...
