Maintenance
Miscellaneous
Maintenance HDSdoc091108 3-7
3
3.7 Miscellaneous
1. Apply a thin film of a NLGI No. 2 grade lithium grease to the blade guide arm every fifty hours of
operation to help prevent it from rusting.
2. Grease the clamp mechanism, loading arm, and side supports with a NLGI No. 2 grade lithium
grease every fifty hours of operation.
3. Oil all chains with Dexron III ATF every fifty hours of operation.
CAUTION! Do not use chain lube. It causes sawdust buildup in
chain links.
4. Lubricate the board return pivot every fifty hours of operation with a NLGI No. 2 grade lithium
grease. Apply grease to the grease fitting on the board return pivot tube.
5. Check the mill alignment every setup. See Section 5, Alignment.
6. Make sure all safety warning decals are readable. Remove sawdust and dirt. Replace any dam-
aged or unreadable decals immediately. Order decals from your Customer Service Representa-
tive.
50
50
50
50
To Next Page
Loading...
