Wood-mizer LT40 DH Series

To Next Page

To Previous Page

Table of Contents Section-Page

Table of Contents HDSdoc091108 iii

SECTION 5 SAWMILL ALIGNMENT 5-1

5.1 Pre-Alignment Procedures......................................................................................... 5-1

5.2 Frame Setup............................................................................................................... 5-2

5.3 Blade Installation And Alignment............................................................................. 5-2

5.4 Saw Head Slide Pad Adjustment............................................................................... 5-5

5.5 Adjusting The Lower Track Rollers.......................................................................... 5-7

5.6 Adjusting Bed Rails To The Blade............................................................................ 5-9

5.7 Blade Guide Arm Vertical Adjustment ................................................................... 5-12

5.8 Blade Guide Arm Horizontal Adjustment............................................................... 5-13

5.9 Aligning the Blade Guides ...................................................................................... 5-15

5.10 Blade Deflection...................................................................................................... 5-16

5.11 Blade Guide Vertical Tilt Adjustment..................................................................... 5-17

5.12 Blade Guide Spacing ............................................................................................... 5-19

5.13 Horizontal Tilt Adjustment...................................................................................... 5-20

5.14 Blade Guide Block Adjustment............................................................................... 5-21

5.15 Horizontal Adjustment of Side Supports................................................................. 5-22

5.16 Vertical Adjustment of Side Supports..................................................................... 5-23

5.17 Clamp Stop/Stop Bolt Adjustment .......................................................................... 5-24

5.18 Saw Head Tilt .......................................................................................................... 5-25

5.19 Blade Height Scale Adjustment............................................................................... 5-26

5.20 Board Return Bracket.............................................................................................. 5-27

Wood-mizer LT40 DH Series - Page 9