Wood-mizer LT40 Series - Saw Head Tilt

Sawmill Alignment
Saw Head Tilt
Sawmill Alignment doc012020 5-26
5
5.18 Saw Head Tilt
As the blade enters a wide log or cant, the outside of the saw head will drop down slightly. To
compensate for the drop, use the lower track roller horizontal bolts to raise the outside of the saw
head 1/16" (1.5 mm).
1. Move the saw head so the blade is positioned 14 3/4" (375 mm) above a bed rail.
2. Adjust the lower track roller horizontal nuts until the blade measures 14 13/16" (376 mm) from the
bed rail near the outer blade guide.
See Figure 5-25.
FIG. 5-25
Inside Lower
Rollers (2)
Bottom Lower
Rollers (2)
Upper Rollers (4)
Stop Screw (2)
Vertical
Adjustment Bolt
Horizontal
Adjustment
Nuts
SM0135B
Stop Bolt (2)
Upper Rollers (4)
Stop Screw (2)
Inside Lower
Rollers (2)
Stop Bolt (2)
Horizontal
Adjustment
Nuts
Bottom Lower Rollers
(2)
Vertical
Adjustment Bolt