Wood-mizer LT40 Series - Clutch Handle Adjustment

Maintenance
Clutch Handle Adjustment
Maintenance HDdoc012020 3-11
3
3.12 Clutch Handle Adjustment
After the drive belts and brake strap are properly adjusted, the clutch handle should lock in the down position
when the drive belts are engaged. If the clutch handle does not stay locked, adjust the handle turnbuckle. See
Section 3.13 for optional Autoclutch adjustment.
1. Remove the blade from the sawmill.
2. Remove the inner belt guard and pull the clutch handle down to engage the drive belts.
3. Hold a straight edge between the bottom and top pivot centers and measure the distance to the middle pivot.
4. Adjust the clutch handle turnbuckle until the center of the middle pivot is 7/16” from the straight edge.
See Figure 3-10.
FIG. 3-10
3H0506
Clutch Handle
Turnbuckle
7/16"
Upper Pivot
Lower
Pivot
Straight
Edge
Upper Pivot
Clutch Handle
Turnbuckle
Straight
Edge
Lower
Pivot